This one is rated for use between 32 – 40 Watts and is also a great little coil. This coil has a best wattage between 60 – 80 Watts and just like most of Voopoo’s coils does this with ease, it provides a really dense vape for those looking for quite an open DTL airflow. There is a downside to this though, over saturation, and as was with previous Pods, you’re going to find a small puddle of eliquid under the Pod if you leave your device sitting for a length of time. The Drag S Pro ships with two different TPP coils for the TPP X Pod, and they both perform quite well, a testament to their huge wicking holes and ability to suck a lot of juice into them. The fill port is covered by a silicone plug, but once you’ve revealed the silicone plug, pull it open (you’ll need fingernails) you’ll find the fill hole is quite a decent size to fit almost all eliquid nozzles into for filling. Gone are the days where you need to take the Pod off of the device to fill, the new TPP X Pod has a lockable rotating ring around the top that you can spin around to reveal the ‘top/side’ fill port. The most noticeable change on this Pod however, is the new way of filling. The new pod has a bigger capacity than the original PnP Pods, this time fitting a huge 5.5mls rather than the original 4.5mls. (only drip tips with external orings will fit) An 810 sized removeable drip tip has also found it’s way onto the TPP X Pod, so you can put your favourite (o-ringed) drip tips on too. Gone is the simple tinted PCTG plastic, and in it’s place is a blend of stainless steel and “clear” PCTG, so that you can see your eliquid level better. And in turn, you can also use the older PnP Pods on these 2 new devices too! It’s not limited to those however, as it is backward compatible with most other Voopoo Pod Mod devices. This is a new Pod that Voopoo have designed for the Drag S Pro and Drag X Pro. A switch to turn it On/Off instead of 3 button presses? Yes please!!Īnother nice little addition to the Drag S Pro is the rubber strip on the base of the device, it’s a nice addon, and means you’re mod sits nicely on the table and doesn’t get scratched. This new switch is also configurable to operate either Power On/Off, or Device Lock/Unlock. The Pod connection has changed from having 3 connection points to now having 2, the airflow adjustment has become a ring, compared to the original’s toggle/slide switch, and my favourite change, actually addition for that matter, the new switch on the front of the device, between the adjustment buttons and charging port. There are some small changes here though. The body is similar to the previous model, staying faithful to the original design, with padded leather embossed heel, and a zinc alloy frame. The new Drag S Pro, is an internal battery powered Pod Mod, with a maximum wattage of 80 Watts, 3000mah battery capacity, 5.5ml e-liquid capacity, 360 degree adjustable airflow, with both button and auto-draw functions, all using Voopoo’s new TPP coils to pump out some impressive vapour. I won’t go through them now, but in each section of the review below. While most of the changes are functional, there are some nice little physical additions too. Visually you might not think a lot has changed, but there are a lot of small modifications that all add up. They’ve listened to the feedback from the vaping community on their original devices, and tweaked this release with a few really cool changes. Let’s take a look at what Voopoo have done with the new Drag S Pro!!īig thanks goes to Voopoo for sending this directly through to me for review!Ī “Pro” version of a device wouldn’t exactly be a “Pro” without some improvements right? Well, that’s exactly what Voopoo have done. I’m not looking at any of those today however, because Voopoo have rejigged their original design, and released their “Pro” versions! I’m going to split these into 2 separate reviews, with this being the first. They were a form factor we’d never seen before, a Pod device that could push out some huge wattage compared to what was already available, and not only that, the placement of the Pod directly onto the base with a 360 degree fit was something that was a first for the vaping world.įast forward to today, and there have been a multitude of models or variances on the Drag S and Drag X including the ‘Plus’ models, and even a similar device with a different name, the “Argus”. When they released their original Drag S & Drag X devices a year or so ago, they made huge waves with vapers clambering to get their hands on one. ![]() Voopoo are the kings of the Pod Mod these days.
0 Comments
Leave a Reply. |